The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, $$l$$ = Length of weld and $${\sigma _{\text{t}}}$$ = Allowable tensile stress for weld metal)?

$$0.5{\text{s}}l{\sigma _{\text{t}}}$$
$${\text{s}}l{\sigma _{\text{t}}}$$
$$\sqrt 2 {\text{s}}l{\sigma _{\text{t}}}$$
$$2{\text{s}}l{\sigma _{\text{t}}}$$

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

6 views Answered 2022-09-01 13:21

Related Questions

When a body is subjected to direct tensile stresses ($${\sigma _{\text{x}}}$$ and $${\sigma _{\text{y}}}$$) in two mutually perpendicular directions, accompanied by a simple shear stress $${\tau _{{\text{xy}}}}{\text{,}}$$ then in Mohr's circle method, the circle radius is taken as?

1 Answers 6 Views

When a body is subjected to biaxial stress i.e. direct stresses ($${\sigma _{\text{x}}}$$) and ($${\sigma _{\text{y}}}$$) in two mutually perpendicular planes accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), then maximum shear stress is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress ($${\sigma _{\text{x}}}$$) in one plane accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), the maximum shear stress is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress ($$\sigma $$) in one plane, then tangential or shear stress on an oblique section of the body inclined at an angle $$\theta $$ to the normal of the section is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress ($$\sigma $$) in one plane, then normal stress on an oblique section of the body inclined at an angle $$\theta $$ to the normal of the section is?

1 Answers 5 Views

Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, σ = yield strength and E = modulus of elasticity)?

1 Answers 6 Views

Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole and $${\sigma _{\text{t}}}$$ = Permissible tensile stress for plate material)?

1 Answers 6 Views

Shear strength of the welded joint for double parallel fillet is (where $$\tau $$ = Allowable shear stress for weld metal)?

1 Answers 6 Views

The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates and $${\sigma _{\text{t}}},\,\tau $$ and $${\sigma _{\text{c}}}$$ = Permissible tensile, shearing and crushing stresses respectively)?

1 Answers 10 Views

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)