This type of drawing shows two lines representing the pipe diameter:?

Single-line
Double-line
Standard piping
Centerline piping

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank?

1 Answers 5 Views

An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank ?

1 Answers 7 Views

What is the shear rate at the pipe wall, in case of laminar flow of Newtonion fluids in a pipe of diameter 'D' & length 'L' incurring a pressure drop 'Δp' with average velocity 'Vavg'?

1 Answers 4 Views

Ten new television shows appeared during the month of September. Five of the shows were sitcoms, three were hour-long dramas, and two were news-magazine shows. By January, only seven of these new shows were still on the air. Five of the shows that remained were sitcoms.?

1 Answers 4 Views

This type of structural steel drawing shows all dimensions necessary for fabrication:?

1 Answers 4 Views

The diameter of the nozzle (d) for maximum transmission of power is given by (where D = Diameter of pipe, f = Darcy’s coefficient of friction for pipe, and l = Length of pipe)?

1 Answers 4 Views

According to Darcy's formula, the loss of head due to friction in the pipe is (where f = Darcy's coefficient, l = Length of pipe, v = Velocity of liquid in pipe, and d = Diameter of pipe)?

1 Answers 4 Views

The loss of head due to viscosity for laminar flow in pipes is (where d = Diameter of pipe, l = Length of pipe, v = Velocity of the liquid in the pipe, μ = Viscosity of the liquid, and w = Specific weight of the flowing liquid)?

1 Answers 5 Views

The pressure drop per unit length for laminar flow of fluid through a long pipe is proportional to (where, A = cross-sectional area of the pipe & D = Diameter of the pipe)?

1 Answers 4 Views

Consider two pipes of same length and diameter through which water is passed at the same velocity. The friction factor for rough pipe is f₁ and that for smooth pipe is f₂. Pick out the correct statement.?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)