The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The resultant stress is given by?

OC
OP
OQ
PQ

LohaHridoy

8 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

8 views Answered 2022-09-01 13:21

Related Questions

When a body is subjected to biaxial stress i.e. direct stresses (σx) and (σy) in two mutually perpendicular planes accompanied by a simple shear stress (τxy), then maximum normal stress is?

1 Answers 5 Views

When a body is subjected to biaxial stress i.e. direct stresses (σx) and (σy) in two mutually perpendicular planes accompanied by a simple shear stress (τxy), then minimum normal stress is?

1 Answers 7 Views

When a body is subjected to direct tensile stresses ($${\sigma _{\text{x}}}$$ and $${\sigma _{\text{y}}}$$) in two mutually perpendicular directions, accompanied by a simple shear stress $${\tau _{{\text{xy}}}}{\text{,}}$$ then in Mohr's circle method, the circle radius is taken as?

1 Answers 6 Views

When a body is subjected to biaxial stress i.e. direct stresses ($${\sigma _{\text{x}}}$$) and ($${\sigma _{\text{y}}}$$) in two mutually perpendicular planes accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), then maximum shear stress is?

1 Answers 5 Views

When a body is subjected to two equal and opposite forces, acting tangentially across the resisting section, as a result of which the body tends to shear off across the section, the stress and strain induced is?

1 Answers 4 Views

When a body is subjected to three mutually perpendicular stresses, of equal intensity, the ratio of direct stress to the corresponding volumetric strain is known as?

1 Answers 5 Views

The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The normal stress on an oblique section making an angle θ with the minor principle plane is given by?

1 Answers 4 Views

The below figure shows the two equal forces at right angles acting at a point. The value of force ‘R’ acting along their bisector and in opposite direction is?

1 Answers 7 Views

The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)?

1 Answers 5 Views

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)