Laminar flow region is said to exist during agitation of a liquid in an agitator, when the value of Reynolds number is?

>10
>100

LohaHridoy

9 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

9 views Answered 2022-09-01 13:21

Related Questions

For pipes, laminar flow occurs when Reynolds number is?

1 Answers 4 Views

Whenever a plate is held immersed at some angle with the direction of flow of the liquid, it is subjected to some pressure. The component of this pressure, in the direction of flow of the liquid, is known as?

1 Answers 4 Views

Laminar flow of a Newtonion fluid ceases to exist, when the Reynolds number exceeds?

1 Answers 4 Views

In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of?

1 Answers 9 Views

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)?

1 Answers 6 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

The loss of head due to viscosity for laminar flow in pipes is (where d = Diameter of pipe, l = Length of pipe, v = Velocity of the liquid in the pipe, μ = Viscosity of the liquid, and w = Specific weight of the flowing liquid)?

1 Answers 5 Views

The depth ‘d’ below the free surface at which the point velocity is equal to the average velocity of flow for a uniform laminar flow with a free surface, will be (where D is the depth of flow)?

1 Answers 23 Views

The velocity at which the flow changes from laminar flow to turbulent flow is called?

1 Answers 5 Views

In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)