When liquid and vapour phases of one component system are in equilibrium (at a given temperature and pressure), the molar free energy is?

More in vapour phase
More in liquid phase
Same in both the phases
Replaced by chemical potential which is more in vapour phase

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

If the liquid and vapor are pure, in that they consist of only one molecular component and no impurities, then the equilibrium state between the two phases is described by the following equations: Pliq = pvap, TLIQ = TVAP, GLIQ = GVAP.

5 views Answered 2022-09-01 13:21

Related Questions

Whenever a plate is held immersed at some angle with the direction of flow of the liquid, it is subjected to some pressure. The component of this pressure, in the direction of flow of the liquid, is known as?

1 Answers 4 Views

When liquid and vapour phase of multi-component system are in equilibrium (at a given temperature and pressure), then chemical potential of each component is?

1 Answers 5 Views

When a system in equilibrium is subjected to a change in temperature, pressure or concentration, the equilibrium is displaced in a direction which tends to undo the effect of the change. This is called the?

1 Answers 4 Views

Condensation of a vapour-gas mixture just begins, when (where, p = partial pressure of the vapour P = vapour pressure of the liquid )?

1 Answers 6 Views

A vertical wall is subjected to a pressure due to one kind of liquid, on one of its sides. The total pressure on the wall per unit length is (where w = Specific weight of liquid, and H = Height of liquid)?

1 Answers 6 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

A reasonably general expression for vapour-liquid phase equilibrium at low to moderate pressure is Φi yi P = Yi xi fi° where, Φ is a vapor fugacity component, Yi is the liquid activity co-efficient and fi° is the fugacity of the pure component i. the Ki value (Yi = Ki xi) is therefore, in general a function of?

1 Answers 6 Views

Vapour which is at a pressure smaller than the saturation pressure for the temperature involved is called a __________ vapour.?

1 Answers 7 Views

If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that?

1 Answers 6 Views

Bound moisture is that liquid which exerts an equilibrium vapor pressure __________ that of the pure liquid at the given temperature.?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)