In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate?

Fully by direct bearing
Fully through fastenings
50% by direct bearing and 50% through fastenings
75% by direct bearing and 25% through fastenings

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

5 views Answered 2022-09-01 13:21

Related Questions

When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be _________ the bearing modulus.?

1 Answers 4 Views

When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)?

1 Answers 5 Views

When a column is subjected to an eccentric load, the stress induced in the column will be?

1 Answers 4 Views

Battening is preferable when thei) column carries axial load onlyii) space between the two main components is not very largeiii) column is eccentrically loaded The correct answer is?

1 Answers 7 Views

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)?

1 Answers 10 Views

A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when?

1 Answers 9 Views

The efficiency of a plate column will be maximum, when the flow is ideal __________ the plate.?

1 Answers 6 Views

The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the bearing and R = Radius of bearing surface)?

1 Answers 5 Views

The frictional torque transmitted in a flat pivot bearing, assuming uniform wear, is (Where μ = Coefficient of friction, W = Load over the bearing, R = Radius of bearing)?

1 Answers 5 Views

If the length of a combined footing for two columns l meters apart is L and the projection on the left side of the exterior column is x, then the projection y on the right side of the exterior column, in order to have a uniformly distributed load, is (where x̅ is the distance of centre of gravity of column loads).?

1 Answers 20 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)