When air is to be compressed at a high pressure, then it is advantageous to use?

Single stage compression
Multistage compression without intercooling
Multistage compression with intercooling
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

When air is to be compressed at a high pressure, then it is advantageous to use Multistage compression with intercooling

4 views Answered 2022-09-01 13:21

Related Questions

When the air is passed through an insulated chamber having sprays of water maintained at a temperature higher than the dew point temperature of entering air but lower than its dry bulb temperature, then the air is said to be?

1 Answers 7 Views

Whitworth compressed steel is obtained when molten steel is subjected to a pressure of?

1 Answers 5 Views

Even though heat transfer co-efficients in boiling liquids is large, use of fins is advantageous, when the entire surface is exposed to __________ boiling.?

1 Answers 4 Views

According to Dalton's law of partial pressures, (where pb = Barometric pressure, pa = Partial pressure of dry air, and pv = Partial pressure of water vapour)?

1 Answers 4 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

If p₁, is the pressure of air entering the L.P. cylinder and p₂ is the pressure of air leaving the L.P. cylinder (or inter-cooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D₁ = Dia. of L.P. cylinder, and D₂ = Dia. of H.P. cylinder)?

1 Answers 6 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.?

1 Answers 4 Views

The critical pressure ratio is given by (where p₁ = Initial pressure of steam, and p₂ = Pressure of steam at throat or critical pressure)?

1 Answers 4 Views

Directions : Following question consists of a statement followed by four arguments I, II, III and IV. You have to decide which of the arguments is a STRONG arguments and which is a WEAK Argument. Statement : Should there be a complete ban on manufacture and use of firecrackers Arguments : I. No. This will render thousands of workers jobless. II. Yes. The firecracker manufacturers use child labour to a large extent. III. Yes. This will be a concrete step to reduce noise and air pollution. IV. No. Use of firecrackers makes certain special occasions more lively and joyful.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)