When a thin cylindrical shell is subjected to an internal pressure, there will be?

A decrease in diameter and length of the shell
An increase in diameter and decrease in length of the shell
A decrease in diameter and increase in length of the shell
An increase in diameter and length of the shell

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

5 views Answered 2022-09-01 13:21

Related Questions

Whenever a plate is held immersed at some angle with the direction of flow of the liquid, it is subjected to some pressure. The component of this pressure, in the direction of flow of the liquid, is known as?

1 Answers 4 Views

The hoop stress in a riveted cylindrical shell of diameter (d), thickness (t) and subjected to an internal pressure (p) is (where $$\eta $$ = Efficiency of the riveted joint)?

1 Answers 5 Views

A vertical wall is subjected to a pressure due to one kind of liquid, on one of its sides. The total pressure on the wall per unit length is (where w = Specific weight of liquid, and H = Height of liquid)?

1 Answers 6 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.?

1 Answers 4 Views

The critical pressure ratio is given by (where p₁ = Initial pressure of steam, and p₂ = Pressure of steam at throat or critical pressure)?

1 Answers 4 Views

In case of a shell and tube heat exchanger, the minimum and maximum baffle spacing is respectively (where, D = inside diameter of the shell)?

1 Answers 7 Views

Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter)?

1 Answers 6 Views

Where does the maximum tensile strength occur in a thick cylindrical vessel subjected to internal pressure?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)