In the above question, the normal stress on an oblique section will be maximum, when θ is equal to?

0°
30°
45°
90°

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

5 views Answered 2022-09-01 13:21

Related Questions

When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy), the maximum normal stress is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy), the minimum normal stress is?

1 Answers 13 Views

When a body is subjected to biaxial stress i.e. direct stresses (σx) and (σy) in two mutually perpendicular planes accompanied by a simple shear stress (τxy), then maximum normal stress is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress (σ) in one plane, then maximum normal stress occurs at a section inclined at _________ to the normal of the section.?

1 Answers 11 Views

When a body is subjected to a direct tensile stress ($$\sigma $$) in one plane, then tangential or shear stress on an oblique section of the body inclined at an angle $$\theta $$ to the normal of the section is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress ($$\sigma $$) in one plane, then normal stress on an oblique section of the body inclined at an angle $$\theta $$ to the normal of the section is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress (σ) in one plane, the maximum shear stress is __________ the maximum normal stress.?

1 Answers 6 Views

According to maximum shear stress failure criterion, yielding in material occurs, when the maximum shear stress is equal to __________ times the yield stress.?

1 Answers 7 Views

The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The normal stress on an oblique section making an angle θ with the minor principle plane is given by?

1 Answers 4 Views

A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)