For a given stress, the ratio of moment of resistance of a beam of square cross-section when placed with its two sides horizontal to the moment of resistance with its diagonal horizontal, is?

$$\frac{1}{2}$$
1
$$\frac{1}{{\sqrt 2 }}$$
$$\sqrt 2 $$

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

5 views Answered 2022-09-01 13:21

Related Questions

When a beam of rectangular cross-section of width b and depth d, is subjected to a shear force F, the maximum shear stress induced will be?

1 Answers 5 Views

Two beams, one of circular cross-section and the other of square cross-section, have equal areas of cross-sections. When these beams are subjected to bending,?

1 Answers 5 Views

A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will?

1 Answers 11 Views

For a beam, as shown in the below figure, the deflection at C is (where E = Young's modulus for the beam material and $$I$$ = Moment of inertia of the beam section.)?

1 Answers 5 Views

The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The normal stress on an oblique section making an angle θ with the minor principle plane is given by?

1 Answers 4 Views

According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $$I$$P) is given by (where, A = Area of the section, $$I$$G = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)?

1 Answers 6 Views

The neutral axis of the cross-section a beam is that axis at which the bending stress is?

1 Answers 6 Views

The neutral axis of the cross-section of a beam is that axis at which the bending stress is?

1 Answers 7 Views

The ratio of the length and depth of a simply supported rectangular beam which experiences maximum bending stress equal to tensile stress, due to same load at its mid span, is?

1 Answers 8 Views

A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)