When connecting two internal SCSI hard disks to a computer, where do you connect the second hard drive?

LohaHridoy
  1. Any open SCSI port on the computer
  2. A Serial port on the first host adapter
  3. An open parallel port on the computer
  4. An open SCSI port on the first hard drive
  5. None of the above

0 like 0 dislike
1 views
Share with your friends

1 Answers

AhmedNazir

Call

Answer: Option 1

Let'

0 like 0 dislike
1 views
Talk Doctor Online in Bissoy App
What is the jumper setting on a SCSI device to configure it to use the fourth SCSI id Remember, SCSI ids start with zero.?

Answer: Option 3 Let'

1 Answers 1 views
Suppose you had an incurable computer virus and decided to wipe out all the data and partitions on your hard drive and reformat. What is the order in which you must delete the partitions?

Answer: Option 3 Let'

1 Answers 1 views
When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:?

Answer: Option 2 Let'

1 Answers 1 views
How many devices can be used on a single SCSI bus Keep in mind that the SCSI host adapter counts as a device.?

Answer: Option 2 Let'

1 Answers 1 views
You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?

Answer: Option 3 Let'

1 Answers 2 views
Hard disks are formatted in the same manner as floppy disks. However, before a hard disk can be formatted, it must first be _____?

Answer: Option 1 Partitioning this is simply a virtual division of a drive or disk into two or more volumes and defining how much space can be allocated to a...

1 Answers 1 views
You just installed a new IDE hard drive, but your system BIOS will not recognize the new drive, what should you check first.?

Answer: Option 2 Let'

1 Answers 1 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.

1 Answers 1 views
In a computer with an eide adapter, where should you connect an ATA CD-ROM drive?

Answer: Option 3 Let'

1 Answers 1 views
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?

Answer: Option 2 Let'

1 Answers 1 views