What is the ratio of fluid carrying capacity of two pipes having diameters d₁ and d₂ respectively?

(d₁/d₂)0.8
(d₁/d₂)0.5
(d₁/d₂)
(d₁/d₂)2

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

5 views Answered 2022-09-01 13:21

Related Questions

There are five persons sitting on a bench. Blue eyed lady sitting in the middle is my mother. At the extreme left, the man with grey hair is my maternal uncle. Lady sitting at the extreme right is having a pimple on her nose and is the wife of person who is sitting between blue eyed lady and grey haired man and has a pointed nose. A lady having marks on her face is the younger sister of the blue eyed lady and sitting on the remaining fifth place. The person having a pointed nose is the son of the blue eyed lady. What is the lady having marks on her face to the man sitting at extreme left ?

1 Answers 5 Views

When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a?

1 Answers 4 Views

Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be?

1 Answers 22 Views

The pressure at a point in a fluid is not the same in all directions, when the fluid is viscous and?

1 Answers 4 Views

The capacity of double-effect evaporator is less than half of the capacity of two single effects, each of which is operating over same terminal temperature difference, when the?

1 Answers 5 Views

Reynolds number (RN) is given by (where h = Film coefficient, l = Linear dimension, V = Velocity of fluid, k = Thermal conductivity, t = Temperature, ρ = Density of fluid, cp = Specific heat at constant pressure, and μ = Coefficient of absolute viscosity)?

1 Answers 20 Views

If p₁, is the pressure of air entering the L.P. cylinder and p₂ is the pressure of air leaving the L.P. cylinder (or inter-cooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D₁ = Dia. of L.P. cylinder, and D₂ = Dia. of H.P. cylinder)?

1 Answers 6 Views

For a given Reynold number as d/D for an orifice increases, Cd will (where, d & D are orifice & pipe diameters respectively).?

1 Answers 4 Views

If three pipes of different diameters, lengths & friction factors are connected in parallel, then (where, Q = flow rate, V= fluid velocity f = friction factor).?

1 Answers 5 Views

The reduction ratio for grinders is defined as(where, Df and Dp are average diameters of feed and product respectively).?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)