What is the type of welding defect is caused due to stresses on heating and cooling called?

Incomplete penetration
Shrinkage void
Slag Entrapment (Inclusions)
Incomplete fusion

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

What is the type of welding defect caused due to shrinkage during solidification and by weld stresses called?

1 Answers 4 Views

What is the welding defect caused due to improper control and poor removal of slog between passes called?

1 Answers 6 Views

In a particular type of welding, flux is prepared in the form of a coarse powder and granulated flux is spread over the joint. What is this type of welding process called?

1 Answers 5 Views

What is the type of welding defect caused due to poor deposition of weld rod is called?

1 Answers 6 Views

What is the type of welding defect caused due to poor manipulation of weld rod or a dirty joint called?

1 Answers 4 Views

If the flame of the welding torch is directed towards the progress of welding, then what will you call the welding technique?

1 Answers 4 Views

The bypass factor (B. P. F.) in case of sensible heating of air is (Where td₁ = Dry bulb temperature of air entering the heating coil, td₂ = Dry bulb temperature of air leaving the heating coil, and td₃ = Dry bulb temperature of heating coil)?

1 Answers 5 Views

The sensible heat factor during the heating and humidification process is given by (where h₁ = Enthalpy of air entering the heating coil, h₂ = Enthalpy of air leaving the heating coil, and hA = Enthalpy of air at the end of humidification process)?

1 Answers 5 Views

The sensible heat factor during cooling and dehumidification process is given by (where h₁ = Enthalpy of air entering the cooling coil, h₂ = Enthalpy of air leaving the cooling coil, and hA = Enthalpy of air at the end of dehumidification process)?

1 Answers 6 Views

The bypass factor, in case of sensible cooling of air, is given by (where td₁ = Dry bulb temperature of air entering the cooling coil, td₂ = Dry bulb temperature of air leaving the cooling coil, and td₃ = Dry bulb temperature of the cooling coil)?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)