What is the most likely cause of an "FDD controller Failure" error message?

you did not set the jumper on the floppy drive to drive A
you forgot to flash CMOS
you installed the floppy disk drive cable backward
your computer's floppy drive is defective
None of the above

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

5 views Answered 2022-09-01 13:21

Related Questions

You get a CMOS checksum error during bootup. What is most likely the cause?

1 Answers 5 Views

After installing a sound card, the system locks up when a parallel port tape backup unit is also used. What is most likely the problem?

1 Answers 5 Views

Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.?

1 Answers 4 Views

Your modem does not respond when you try to dial out. You try another modem on another computer and get the same result. What is the most likely problem?

1 Answers 4 Views

A keyboard locks up intermittently even when replaced with a new keyboard. What is the LEAST likely cause of the problem?

1 Answers 6 Views

What is the value of message $name = “John”; $message = ‘Hello, $name’;?

1 Answers 5 Views

Your computer has gradually slowed down. What's the most likely cause?

1 Answers 8 Views

What component would most likely cause a "parity error"?

1 Answers 10 Views

After upgrading your computer to a new DOS version, an older application displays the error message "Incorrect DOS version". What should you do to run this application?

1 Answers 5 Views

After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)