Bissoy.com
Doctors Medicines MCQs Q&A

Which one is not contained in MICR code?

Which one is not contained in MICR code? Correct Answer Country code

যে মেশিন Magnetic Ink Character Recognition (MICR) লেখা পড়তে পারে, তাকে MICR Reader বলে। চৌম্বক কালি বা ফেরোসোফেরিক অক্সাইডযুক্ত কালির সাহায্যে MICR লেখা হয়। এই কালিতে লেখা কাগজ শক্তিশালী চৌম্বক ক্ষেত্রে রাখলে কালির ফেরোসোফেরিক অক্সাইড চুম্বকে পরিণত হয়। এরপর এই বর্ণচুম্বকগুলো তড়িৎ চৌম্বকীয় আবেশের দ্বারা তড়িৎ প্রবাহ উৎপন্ন করে। এই পদ্ধতিতে ব্যাংকের চেক নম্বর পড়া ও লেখা হয়।

Related Questions

In Banks we use MICR cheques. What does this 'MICR' stand for?
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network?
1. Gateway (config) # ip route 0.0.0.0 0.0.0.0 206.143.5.2
2. Gateway (config) # router rip
3. Gateway (config-router) # network 206.143.5.0
4. Gateway (config-router) # network 206.143.5.0 default
Consider the following statements:
1. Section 34 of Indian Penal Code requires two persons whereas Section 149 of Indian Penal Code require five persons.
2. Section 34 of Indian Penal Code requires common intention, whereas Section 149 of Indian Penal Code requires common object
3. Section 34 of Indian Penal Code and Section 149 of Indian Penal Code both require presence of a prior consent
4. Section 34 of Indian Penal Code and section 149 of Indian Penal Code. Both create specific offence
Which of the above statements are correct?
What two multicast addresses does OSPFv3 use?
1. FF02::A
2. FF02::9
3. FF02::5
4. FF02::6