Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

During the short-circuit test of a synchronous machine, which of the following are accounted for in the short-circuit test loss? (i), I2R loss in the armature winding due to the flow of short-circuiting (AC) current (ii) Local core loss caused by armature leakage flux (iii) Core loss due to resultant air-gap flux. (iv) Windage and friction loss
Consider the following statements for Norton’s theorem: 1. Short the branch resistance through which current is to be calculated. 2. Obtain the current through this short-circuited branch, using any of the network simplification techniques. 3. Develop Norton’s equivalent circuit by connecting current source IN with the resistance RN in series with it Which of the above statements are correct?
Which of the following statements are true about quicksand? i. It is only a condition but not a type of sand. ii. It is a condition and a type of sand too. iii. Quicksand condition reaches when critical hydraulic gradient is approximately equal to unity. iv. Quicksand condition occurs more commonly in coarse grained sand or gravels than fine sand.
What are the steps required in sequence to solve a circuit using superposition theorem? (a) Select any one source and short circuit all other voltage sources. (b) Find out the current or voltage across the required element, due to the source under consideration. (c) Open all current sources, if the internal impedance is not known. If known replace them by their impedances. (d) Add all the individual effects produced by individual sources to obtain the total current in or across the voltage element. Code :
When an electric current coil of a wattmeter is connected to the electric current path R and the voltage coil is connected between the electric current R path and the neutral side of the balanced three phase supply, it shows 10 kW. The line voltage along the phase sequence RYB is 400 V. The current drawn by the current path is 54 A. What is the new reading of the wattmeter if the voltage coil is connected between the lines B and the Y paths, even if the electric current coil is continuously present in the line R?
What is the phase current in phase Y and in phase B out of R-Y-B when sudden short circuit to all three phases occurs at no load? It is given that after fault current in phase R is equal (Vm Sin ωt)
In a short circuit condition, the current flow is present and there is no voltage. What will be the power dissipated within the circuit?
Consider the following statements: When a thick plate is subjected to external loads: 1. State of plane stress occurs at the surface 2. State of plane strain occurs at the surface 3. State of plane stress occurs in the interior part of the plate 4. State of plane strain occurs in the interior part of the plate Which of these statements are correct?
Which of the following statements is/are correct? 1. The earth is nearest to the Sun at Perihelion, which generally occurs on January 3. 2. The earth is farthest away from the Sun at Perihelion, which generally occurs on July 4. 3. The earth is farthest away from the Sun at Aphelion, which generally occurs on July 4. 4. The earth is nearest to the Sun at Aphelion, which generally occurs on January 3. Select the correct answer using the code given below:
In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :