Related Questions

In a drag link quick return mechanism, the shortest link is always fixed. The sum of the shortest and longest link is
A equal to sum of other two
B greater than sum of other two
C less than sum of other two
D none of the mentioned
The direction of linear velocity of any point on a link with respect to another point on the same link is
A parallel to the link joining the points
B perpendicular to the link joining the points
C at 450 to the link joining the points
D none of the mentioned
In a mechanism, usually one link is fixed. If the fixed link is changed in a kinematic chain, then relative motion of other links
A will remain same
B will change
C will not occur
D none of the mentioned
When a new trunk link is configured on an IOS-based switch, which VLANs are allowed over the link?
A By default, all VLANs are allowed on the trunk.
B No VLAN's are allowed, you must configure each VLAN by hand.
C Only configured VLAN's are allowed on the link.
D Only extended VLAN's are allowed by default.
When the time to establish link is large and the size of data is small, the preferred mode of data transfer is
A Circuit switching
B Packet switching
C Time division multiplexing
D All of the above
E None of the above
When you start up the computer the boot up storage at which the BIOS versions manufacturer and data are displayed on the monitor is called
A Bootstrap
B Power on self test (POST)
C System configuration
D Kernel loading
The speed at which the monitor accepts data is called:
A bandwidth
B response time
C interlacing
D scanning
E None of the above
The purpose of a link is to
A transmit motion
B guide other links
C act as a support
D all of the mentioned
In the following sentence the word principal' occurs three times "The principal (1) aim of the principal (2) of the college was to help build new roads to link the area's principal (3)schools" Indicate the use(s) in which the meaning of the word “Principal is ‘chief or main',
A Use (1)
B Use(2)
C Use (3)
D Both (1) & (3)
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as ________ double cover butt joint.
A Single riveted
B Double riveted
C Multi riveted
D None of these

Next steps