Bissoy.com
Doctors Medicines MCQs Q&A

Typical solvent polymerisation reaction conditions for the production of high density polythene by Zeigler process is

Typical solvent polymerisation reaction conditions for the production of high density polythene by Zeigler process is Correct Answer 7 kgf/cm<sup>2</sup> and 70°C

Related Questions

A chain growth polymerisation reaction consists of three different types of reaction namely initiation reaction, propagation reaction & termination reaction. Chain growth polymerisation reaction is not involved in the manufacture of
Low density polythene as compared to high density polythene is
Which of the following polymers are produced by employing all bulk polymerisation, solution polymerisation & suspension polymerisation technique of addition (chain) polymerisation?
Which of the following polymers are produced by employing all bulk polymerisation, solution polymerisation & suspension polymerisation technique of addition (chain) polymerisation?
An object X sinks in liquids P and Q but floats in liquid R. Which of the following conclusions can be made from these observations? A) Density of X is more than the density of P B) Density of X is less than the density of R C) Density of P is equal to the density of R D) Density of P is less than the density of R
Low pressure Zeigler process of polythene manufacture
Low pressure Zeigler process for the manufacture of polythene uses a catalyst which is
In a batch process, the reaction takes place in the presence of an acid medium. The acid is drained from the reaction vessel at the rate of 15ml/s as a result of the density difference of the acid from the reacting component. To avoid wastage of acid, it is recycled to an acid tank which has 1000 L capacity. The acid drained from the reaction vessel, picks up 50 g/L solids from the reactor. Acid is fed once again to the process from acid tank. When the process is started, the acid is almost pure in the tank as a result of filtration. As the reaction proceeds, acid in the tank gets more and more contaminated with the solids. The concentration of the solids should not exceed 100 g/L from the process point of view. The batch time is 16h. Estimate whether the concentration of the solids will exceed 100g/L during the batch reaction.
Which of the following is not suitable for the polymerisation of ethene to form high-density polythene?
The vapor pressure of the solvent decreased by 10 mm Hg, when a non-volatile solute was added to the solvent. The mole fraction of the solute in the solution is 0.2. What should be the mole fraction of the solvent, if the decrease in vapor pressure of the solvent is required to be 20 mm Hg.?