Related Questions

Rashna Company collected the following data in its accounting records in 2014 : From the income statement : Depreciation expense Tk. 1,000 Loss on sale of equipment 3,000 From the comparative balance sheet : Beginning balance , equipment Tk. 12,500 Ending balance , equipment 8,000 Beginning balance , accumulated depreciation 2,000 Ending balance , accumulated depreciation 2,400 No new equipment was purchased during the year. The equipment was sold at the end of the year. What was the cash in -flow from the sale of equipment in 2014?
A Tk, 3,900
B Tk. 1,000
C Tk. 900
D Tk. 600
__________ mill is normally used for grinding of talc.
A Tube
B Compartment
C Ring-roll
D Pebble
Brinell Hardness Number (BHN) for talc is approximately in the range of
A 1-5
B 20-30
C 100 -150
D 200 - 250
The softest material just next to talc in the Mho's scale is
A Quartz
B Gypsum
C Feldspar
D Fluorite
The softest material just next to talc in the Mhos scale is
A Quartz
B Gypsum
C Feldspar
D Fluorite
Powder metallurgy process does not make metal powder by
A Atomisation
B Grinding/milling
C Hammering
D Electrolytic deposition
The process of heating the cold pressed metallic powder is called __________ in powder metallurgy.
A Precipitation
B Fusion
C Sintering
D Agglomeration
When coal is first dried and then crushed to a fine powder by pulverizing machine, the resulting fuel is called
A Wood charcoal
B Bituminous coal
C Briquetted coal
D None of these
Mixing of light fine powder such as insecticides is done by
A Banbery mixer
B Pug mill
C Impact wheels
D Kneader
Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.
A Acrylic
B Polyester
C Nylon 6:6
D Polypropylene

Next steps