Related Questions

With increase in absolute humidity, the dew point of an unsaturated mixture of air and water vapor (at constant pressure and temperature)
A Increases
B Remains unchanged
C Decreases
D Decreases linearly
When the air is passed through an insulated chamber having sprays of water maintained at a temperature higher than the dew point temperature of entering air but lower than its dry bulb temperature, then the air is said to be
A Cooled and humidified
B Cooled and dehumidified
C Heated and humidified
D Heated and dehumidified
For unsaturated air, the dew point temperature is __________ wet bulb temperature.
A Equal to
B Less than
C More than
D None of these
As relative humidity decreases, the dew point temperature will be ________ wet bulb temperature.
A Same as
B Lower than
C Higher than
D None of these
The difference between dry bulb temperature and dew point temperature, is called
A Dry bulb depression
B Wet bulb depression
C Dew point depression
D Degree of saturation
When water is sprayed on air, passing through an insulated chamber maintained at a temperature higher than the dew point of entering air but lower than its dry bulb temperature, then the air is
A Cooled and dehumified
B Heated and humidified
C Cooled and humidified
D Heated and dehumidified
Point A is 10 miles West of Point B. Point b is 30 miles North of pint C. Point C is 20 miles East of Point D. What is the distance (in miles) between Point A and Point D?
A 1010
B 1020
C 2010
D 3010
Point A is 10 km west of point B. Point B is 30 km north of point C. Point C is 20 km east of point D. What is the distance between point A and D?
A 1020Km
B 1010Km
C 2010Km
D 3010Km
With increase in C/H ratio of a fuel, the dew point of flue gases
A Increases
B Decreases
C Remains same
D May increase or decrease ; depends on the type of fuel
Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele's method, this method
A Is more accurate in finding the number of equilibrium stages
B Accounts for the enthalpy changes in the process
C Facilitates direct calculation of heat load on reboiler & condenser from, the diagram used in this method
D All of the above

Next steps