Related Questions

In the design of a paddle agitator, the ratio (paddle dia/tank dia) is normally taken as
A 0.1
B 0.8
C 0.25
D 0.5
The raio, (properller agitator dia/tank dia) is normally taken as
A 0.15-030
B 0.5-0.65
C 0.75-0.85
D 0.60-0.90
Packed column distillation is limited to the column __________ metres.
A [

A. Height

B. Diameter

B Both A & B
C Neither A nor B
A distillation column with N plates is being operated under normal conditions. At some point of time, the operation is shifted to total reflux condition (i.e., no product and residue are being withdrawn and feed to the column is stopped). At the new steady state,
A Composition of vapors and that of liquid do not vary throughout the column
B Reboiler load and condenser load are minimum
C The top and bottom compositions are unchanged with and without total reflux
D The top and bottom compositions correspond to the maximum enrichment available
Polar organic compounds are normally used as separating agents for the azeotropic and extractive distillation. Which of the following is the most important factor to be considered for the choice of the separating agent for extractive distillation?
A Cost
B Availability
C Toxicity
D Selectivity
If the amount of the steam used in steam distillation is increased, the temperature of distillation
A Increases
B Decreases
C Remains unchanged
D Depends on relative volatility
Vacuum maintained in the vacuum distillation tower of the crude distillation plant is about __________ mm Hg (absolute).
A 5-10
B 30-80
C 150-250
D 350-400
According to Euler's column theory, the crippling load for a column of length (l) fixed at both ends is __________ the crippling load for a similar column hinged at both ends.
A Equal to
B Two times
C Four times
D Eight times
-Column row+Column row+Column row এই ফরমূলা কিসের?
A ভাগ এর
B যোগ এর
C গুণ এর
D বিয়োগ এর
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
A 1 d
B 1.25 d
C 1.5 d
D 1.75 d

Next steps