Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
In a laboratory test run, the rate of drying was found to be 0.5 × 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)
Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature and $$\mu $$ = Degree of saturation)
Match List-I with List-II and select the correct answer using the code given below the Lists: List I (Low-Latitude Climate) List I (Characteristic) A. Wet Equatorial 1. Uniform temperatures, mean near 27°C  B. Monsoon and trade wind coastal 2. Marked temperature cycle with very high temperature before the rainy season C. Wet-dry tropical  3. Temperatures show an annual cycle with a high temperature in the high-Sun season Strong temperature cycle. with intense temperature during the high-Sun season  D. Dry tropical 4. Strong temperature cycle, with intense temperature during the high-Sun season
Consider the following statements: 1. The relative humidity of air does not change with temperature as long as specific humidity remains constant. 2. Dew-point temperature is the temperature at which condensation begins when air is cooled at constant volume. 3. Saturated air passing over a water surface does not cause change of air temperature. 4. For saturated air, dry-bulb, wet-bulb and dew-point temperatures are identical. Which of the above statements are correct?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Consider the following statements regarding clutches 1. Dry clutch has higher coefficient of friction compared to wet clutch 2. The torque capacity of wet clutch is high compared to dry clutch. 3. The engagement in a dry clutch is smoother than in case of wet clutch. Which of the above statements is/are correct ?
Shweta has connected a cell with a bulb. The bulb didn't glow. What could be the reasons? A. Bulb was connected by the positive terminal from both ends. B. One end of the bulb was connected with a positive terminal and another end was connected with a negative terminal.  C. Bulb was connected by the negative terminal from both ends D. Bulb was fuse.
The bypass factor (B. P. F.) in case of sensible heating of air is (Where td₁ = Dry bulb temperature of air entering the heating coil, td₂ = Dry bulb temperature of air leaving the heating coil, and td₃ = Dry bulb temperature of heating coil)