Related Questions

Heat transfer by radiation from a hot body will be most rapid, if its surface is __________ because of its higher emissivity.
A White & rough
B Black & rough
C White & polished
D Black & polished
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
When heat is transferred from hot body to cold body, in a straight line, without affecting the intervening medium, it is referred as heat transfer by
A Conduction
B Convection
C Radiation
D Conduction and convection
The pain in angina pectoris may radiate to
A Chin
B Epigastrium
C Interscapular region
D Occiput
E Radial side of the forearm
In cardiac arrest chest pain may radiate to-
A Right habd
B Right leg
C Left hand
D Left leg
The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)
A $$\frac{{{\text{P}}l{\text{A}}}}{{\text{E}}}$$
B $$\frac{{{\text{P}}l}}{{{\text{AE}}}}$$
C $$\frac{{\text{E}}}{{{\text{P}}l{\text{A}}}}$$
D $$\frac{{{\text{AE}}}}{{{\text{P}}l}}$$
When heat is transferred from one particle of hot body to another by actual motion of the heated particles, it is referred to as heat transfer by
A Conduction
B Convection
C Radiation
D Conduction and convection
According to Newton's law of cooling, the heat transfer from a hot body to a cold body is
A Directly proportional to the surface area
B Directly proportional to the difference of temperatures between the two bodies
C Either (A) or (B)
D Both (A) and (B)
How are the efficiencies of any heat engine (miu) and reversible heat engine (miuR) compared, when both are operating between same heat source and same heat sink?
A miu = miuR
B miu>miuR
C miu
D none of these
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
A scaling factor
B forming factor
C resisting factor
D fouling factor

Next steps