Related Questions

Fqra cold viscous feed, backward feed gives __________ than forward feed.
A A higher capacity
B A lower capacity
C Lower economy
D None of these
The advantage of backward feed multiple effect evaporators over forward feed units is that
A Heat sensitive material can be handled
B There is no additional cost of pumping
C Most concentrated liquid is at highest temperature
D Equal heat transfer co-efficients exist in various effects
In a backward feed multiple effect evaporator
A Feed is introduced in the first effect
B Feed flows from low pressure to high pressure
C No pumps are required between successive effects
D None of these
A multiple effect evaporator as compared to a single effect evaporator of the same capacity has
A Lower heat transfer area
B Lower steam economy
C Higher steam economy
D Higher solute concentration in the product
A dilute aqueous solution is to be concentrated in an evaporator system. High pressure steam is available. Multiple effect evaporator system is employed, because
A Total heat transfer area of all the effects is -less than that in a single effect evaporator system
B Total amount of vapor produced per Kg of feed steam in a multiple effect system is much higher than in a single effect
C Boiling point elevation in a single effect system is much higher than that in any effect in a multieffect system
D Heat transfer co-efficient in a single effect is much lower than that in any effect in a multieffect system
In a forward feed multiple effect evaporator, the pressure is
A Highest in last effect
B Lowest in last effect
C Same in all effects
D Dependent on the number of effects
In a forward feed multiple effect evaporator unit
A Viscosity of liquid is highest in first effect
B Transfer from effect to effect is done by pumps
C No pump is required to withdraw the product from the last effect
D None of these
For a cold dilute feed to produce thick viscous liquor, backward feeding as compared to forward feeding results in
A Increased economy
B Decreased economy
C Lower capacity
D No effect on economy
For the same heat transfer area and the terminal conditions, the ratio of the capacities of a single effect evaporator to a triple effect evaporator is
A 3
B 0.33
C 1
D 1.33
Evaporator used for concentrating tomato juice is made of
A Nickel
B Brass
C Stainless steel-glass lined
D Cast iron-rubber lined

Next steps