In turbulent flow, a rough pipe has the same friction factor as a smooth pipe

In turbulent flow, a rough pipe has the same friction factor as a smooth pipe Correct Answer When the roughness projections are much smaller than the thickness of the laminar film

Bissoy MCQ

Related Questions

Consider two pipes of same length and diameter through which water is passed at the same velocity. The friction factor for rough pipe is f1 and that for smooth pipe is f2. Pick out the correct statement.
Friction factor for a hydraulically smooth pipe at NRe = 2100 is f1. If the pipe is further smoothened (i.e., roughness is reduced), the friction factor at the same value of NRe, will
For turbulent flow in smooth circular pipe, the velocity distribution is a function of the distance 'd' measured from the wall of the pipe and the friction velocity 'v', and it follows a __________ relationship.
In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of
The friction factor for turbulent flow in a hydraulically smooth pipe
For a smooth conduit, which of the following is the value of friction factor (f) for laminar and turbulent flow respectively?
Two pipes A and B can fill an empty cistern in 18 and 27 hours, respectively. Pipe C can drain the entire cistern in 45 hours when no other pipe is in operation. Initially, when the cistern was empty Pipe A and Pipe C were turned on. After a few Pipe A was turned off and Pipe B was turned on instantly. In all, it took 55 hours to fill the cistern. For how many hours was Pipe B turned on?
Transition length for turbulent flow in smooth pipe is equal to __________ times the pipe diameter.
A tank is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the tank in the same time during which the tank is filled by the third pipe alone. The second pipe fills the tank 5 hours faster than the first pipe and 4 hours slower than the third pipe. The time required by the first pipe is:
A circular pipe of radius 7 cm is used for water flow transmission. This pipe is moulded into another pipe with a square cross-section keeping the length same. (Ignore the thickness of the pipe). Calculate the hydraulic diameter of the moulded pipe. (Take π = 22/7).