Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

An example of autothermal reactor operation is
What type of reactor is used in Tarapur atomic power plant? a. Molten salt reactor b. Boiling water reactor c. Fast neutron reactor d. None of these
A Composition of carbon dioxide, oxygen and nitrogen with mole ratio 1:2:5 with 4 moles of oxygen, enters a reactor with a flow rate of 100 kg/s, the ratio of rates of leaving the reactor of the three is 5:2:1, and 5 moles of nitrogen leaves the reactor, what is the total number of moles leaving the reactor?
In case of a __________ reactor, the composition in the reactor and at the exit of the reactor is the same.
Consider the following statements: 1. The chain reaction process is used in nuclear bombs to release a vast amount of energy, but in nuclear reactors, there is no chain reaction. 2. In a nuclear reactor, the reaction is controlled, while in nuclear bombs, the reaction is uncontrolled. 3. In a nuclear reactor, all operating reactors are ‘critical’, while there is no question of ‘criticality’ in case of a nuclear bomb. 4. Nuclear reactors do not use moderators, while nuclear bombs use them. Which of the above statements about operational principles of a nuclear reactor and a nuclear bomb is / are correct?
In order to prepare Lithium nitride, air is passed gently over a reactor. Suppose that Nitrogen diffuse to a length 5cm before getting reacted with Lithium. Nitrogen reacts with lithium quickly so that partial pressure of Nitrogen at that point is 0. Reactor is a cylinder of length 10cm and diameter 2cm. Assume air to be a mixture of Nitrogen and Oxygen only. The temperature is 298K and total pressure 1atm. Diffusivity of N2 in O2 is 2*10-5m2/s. Calculate the Molar flux (mol/m2.s) of N2 at a distance of 2.5cm from the top with respect to an observer moving with twice the mass average velocity a direction towards the liquid surface. (R=8.205*10-5m3atmK-1mol-1). Assume z=0 at the top of the reactor.
In which of the following reactor it is possible to add remove and process the reactor fuel during reactor operation?
The fresh feed to an ammonia synthesis reactor contains nitrogen, hydrogen and 2.0 mole per cent inerts. The molar ratio of H2:N2 is 3:1. The product stream consists of pure ammonia. Since conversion in the reactor is only 15%, a recycle stream is used and in order to avoid build-up of inerts, a purge stream is withdrawn. The rate of purge stream is adjusted to keep inert concentration in the recycle stream at 8 mole per cent. For a fresh feed rate of 100 moles/hr. Note that recycle stream contains only nitrogen, hydrogen and inerts. The N2:H2 ratio of 1:3 is maintained in every process stream, and calculate the moles of nitrogen entering the reactor and in the recycle stream?
Lysine is being produced in a lab-scale reactor by a threonine auxotroph. After 2 weeks of operation it was observed that the concentration of lysine in the reactor was gradually decreasing. Microbiological assays of reactor samples showed absence of contamination and recorded data showed no change in the operating conditions. The most probable reason for decrease in lysine concentration may be attributed to
A reactor having a salvage value of Rs. 10000 is estimated to have a service life of 10 years. The annual interest rate is 10%. The original cost of the reactor was Rs. 80000. The book value of the reactor after 5 years using sinking fund depreciation method will be Rs.