Related Questions

The latent heat of steam at pressures greater than atmospheric in comparison to latent heat at atmospheric pressure is
A Less
B More
C Equal
D May be less or more depending on temperature
An equipment which converts the latent or sensible heat of one fluid into the latent heat of vaporisation of another, is called a
A Boiler
B Heat exchanger
C Recuperator
D Regenerator
The latent heat of steam with increase of pressure
A Remain same
B Increases
C Decreases
D Behaves unpredictably
Latent heat of dry steam at atmospheric pressure is equal to
A 539 kcal/kg
B 539 BTU/lb
C 427 kcal/kg
D 100 kcal/kg
In a steam engine, superheated steam from the boiler is fed into the steam chest at a pressure of
A 10 atmospheres
B 20 atmospheres
C 30 atmospheres
D 40 atmospheres
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
An aqueous solution of methanol is to be distilled in a tray column. High pressure steam is available as a source of heat. For a given reflux ratio and overhead composition, two options are being explored; (i) a reboiler is used and (ii) no reboiler is used but steam is fed directly to the bottom of the column. As compared to option (i), in option (ii)
A Less number of trays are required
B Composition of the residue remains unchanged
C More number of trays are required but the residue composition remains unchanged
D More number of trays are required and the residue composition is more dilute in methanol
In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.
A Equal to
B Less than
C More than
D None of these
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
In case of non-condensing steam engines, the pressure of steam in the cylinder during exhaust stroke is _________ the condenser pressure.
A Equal to
B Lower than
C Higher than
D None of these

Next steps