The pressure drop per unit length for laminar flow of fluid through a long pipe is proportional to (where, A = cross-sectional area of the pipe & D = Diameter of the pipe)

The pressure drop per unit length for laminar flow of fluid through a long pipe is proportional to (where, A = cross-sectional area of the pipe & D = Diameter of the pipe) Correct Answer $$\frac{1}{{\text{A}}}$$

Bissoy MCQ

Related Questions

Consider the 5 × 5 matrix \[{\text{A}} = \left[ {\begin{array}{*{20}{c}} 1&2&3&4&5 \\ 5&1&2&3&4 \\ 4&5&1&2&3 \\ 3&4&5&1&2 \\ 2&3&4&5&1 \end{array}} \right
The pressure drop per unit length of pipe incurred by a fluid 'X' flowing through pipe is $$\Delta {\text{p}}.$$  If another fluid 'Y' having both the specific gravity & density just double of that of fluid 'X', flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be
For laminar flow of Newtonion fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, $$\mu $$ = fluid viscosity)
Eigen values of the matrix \[\left[ {\begin{array}{*{20}{c}} 0&1&0&0 \\ 1&0&0&0 \\ 0&0&0&{ - 2i} \\ 0&0&{2i}&0 \end{array}} \right
Let A be an m × n matrix and Ban n × m matrix. It is given that determinant ($$I$$m + AB) = determinant ($$I$$n + BA), where $$I$$k is the k × k identity matrix. Using the above property, the determinant of the matrix given below is
\[\left[ {\begin{array}{*{20}{c}} 2&1&1&1 \\ 1&2&1&1 \\ 1&1&2&1 \\ 1&1&1&2 \end{array}} \right
Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation?
1. Fluid flow is frictionless & irrotational
2. Fluid flow is steady
3. Fluid flow is uniform & turbulent
4. Fluid is compressible
5. Fluid is incompressible
The flow through a circular pipe is laminar. Now, the fluid through the pipe is replaced with a more viscous fluid and passed through the pipe again with the same velocity. What can we say about the nature of this flow?
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by (where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3.μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
Applying a pressure drop across a capillary results in a volumetric flow rate 'Q' under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is
What is the shear rate at the pipe wall, in case of laminar flow of Newtonion fluids in a pipe of diameter 'D' & length 'L' incurring a pressure drop 'Δp' with average velocity 'Vavg'?