Related Questions

Fire in fuel gas pipelines is extinguished most effectively by
A Spraying water
B Blanketting the area with nitrogen atmosphere
C Fire fighting foam
D None of these
Fire on fuel oil lines can be extinguished by
A Foam
B Steam
C Water
D Carbon dioxide
A fire broke out in a garments factory. How many minutes would it take for a fire truck to got to the fire 10 miles away if it travels at a rate of 20 mph?
A 10/20
B 20/10
C 60 * (10/20)
D 60 * (20 /10)
Gasification of the solid fuel converts its organic part into combustible by interaction with air/oxygen and steam so as to obtain a secondary gaseous fuel of high calorific value having no ash. Gasification reactions are normally carried out at about __________ °C.
A 400-500
B 900-1000
C 1400-1500
D 1700-1800
Normally, which of the following is used, when a large-scale conversion from AC. to D.C. power is required?
A Motor-generator set
B Motor converter
C Rotary converter
D Mercury arc rectifier
Dilute wine was used as a thermometric liquid initially to develop temperature scale. First emperical temperature scale developed was the __________ scale.
A Kelvin
B Centigrade
C Fahrenheit
D Reaumer
Travelling at a constant speed of 32 miles per hours, a certain motorboat consumers 24gallons of fuel per hour. What is the fuel consumption of his boat this speed measured in miles per gallons of fuel?
A 2/3
B 3/4
C 4/5
D 4/3
A certain truck uses 18 gallons of diesel fuel in traveling 270 miles. In order for the truck to travel the same distance using 10 gallons of diesel fuel, by how many miles per gallon must the truck's fuel mileage be increased.
A 12
B 15
C 27
D 9
Two tanks are filled to capacity with automobile fuel. The first tank holds 600 gallons more than the second tank. If 100 gallons were to be pumped from each tank, the first tank would then contain 3 times as much fuel as the second tank. What is the total number of gallons of fuel in the two full tanks?
A 1,400
B 1,200
C 1,000
D 900
The processing, which normally consists of a small computer with one or more peripheral devices, connected via a high-speed line to the large control computer is known as
A On-line processing
B Remote-terminal processing
C Batch mode processing
D Intelligent terminal Processing
E None of the above

Next steps