Dislocation cross-slip is difficult in those materials, which have

A Large number of slip systems

B High work hardening rate

C Coarse grain size

D Low stacking fault energy

Correct Answer: Low stacking fault energy

Bissoy MCQ Team

#Chemical Engineering #Chemical Engineering Basics

Related Questions

The elastic strain energy of a unit length of an edge dislocation as compared to that of a screw dislocation is

The materials which fracture even at small strains are termed as brittle, while those materials which exhibit an appreciable deformation before failure are termed as

Thermoplastic materials are those materials which

It is difficult to pass this admission test. Here 'difficult' is-

The reason clean energy is hard to come by is that we've spent the past 150 years depending on oil, and it's quite difficult to make the switch. Here "difficult to make the switch" is related to

A. there was the hope that in another existence a greater happiness would reward one B. previous existence and the effort to do better would be less difficult too, when C. it would be less difficult to bear the evils of one's own life, if D. One could think that they were but the necessary outcome of one's errors in a

Markets in which funds are transferred from those who have excess funds available to those who have a shortage of available funds are called.

Those materials are well suited for making permanent magnets which have ________ retentivity and ________ coercivity.

Those magnetic materials are best suited for making armature and transformer cores which have ________permeability and _________hysteresis loss.

Isotropic materials are those which have the same

Next steps

Browse more MCQs for practice
Take a merit test and check your score
Job preparation MCQs
Health Q&A on Bissoy

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1127)

Admission (755)

এসএসসি (13)

এইচএসসি (5)