Related Questions

A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will
Which of the following equation best represents the mutual inductance between stator and rotor in a single phase cylindrical rotor synchronous machine? (where θr= space angle between stator and rotor field axis)
In a three rotor system, for the middle rotor, if the stiffness of both the length either side of the rotor is increased to two times what will be the effect on total stiffness of the middle rotor?
In a three phase induction motor of rotor impedance as (0.2+j0.2), rotor current in each phase lags behind the generated emf in that phase to rotor by a power factor angle of _________
A properly shunted center zero galvanometer is connected in the rotor circuit of a 6-pole, 50 hz wound rotor induction motor. If the makes 90 complete oscillations in one minute, the rotor speed is?
The rotor of the induction motor must never run at synchronous speed because then the relative speed between the rotating flux and rotor will be _________
A center ammeter connected to the rotor end circuit of a 6-pole,50 Hz, induction motor makes 45 complete oscillations in a minute. Then the rotor speed and the speed of stator field w.r.t. rotor is?
A 3-phase, 50 Hz, 6-pole induction motor has a shaft output of 10kW at 930 rpm. Friction and windage losses is 1% of the output. Total stator losses is 600W. What is the rotor input?
In an induction motor, what is the ratio of the rotor copper loss to rotor input?
The power input to an induction motor is 50 kW when it is running at 4% slip. If the stator resistance and core losses are neglected, the rotor copper loss is