Related Questions

The oldest rocks in the earth's crust were once molten, and came from deep inside the earth. The molten rock, called magma, spewed out in volcanic eruptions during the earth's early life and solidified into hard rock's called
Rocks formed by solidification of molten magma at the surface of the earth are called
What kind of rock is formed by the cooling and solidification of magma?
It is more or less parallel sided vertical wall of igneous rock formed due to upward intrusion of molten magma through fissures or cracks and is a common occurrence in coalfields. Guess it as
Rocks that are formed by the cooling of molten material (called magma) at or relatively near the earth surface is called
In case of Igneous rock, if cooling of magma is slow, then that rock's texture will be
Igneous rocks are formed from molten rock material. Which one of the following is not an igneous rock?
Which word is defined as a “vent in the crust of Earth or another planet or satellite, from which issue eruptions of molten rock, hot rock fragments, and hot gases”?
To constitute a matter of res judicata which of the following conditions must concur?
1. The matter directly and substantially in issue in the subsequent suit or issue must be the same matter which was directly and substantially in issue either actually (section 11, explanation III) or constructively (section 11, explanation IV) in the former suit
2. The former suit must have been a suit between the same parties under whom they or any of them claim. Explanation VI of Section 11 must be read with this condition
3. The parties as aforesaid must have litigated under the same title in the former suit
4. The court which decided the former suit must have been a court competent to try the subsequent suit of the suit in which such issue has been subsequently raised. Explanation II of section 11 is to be read with condition
5. The matter directly and substantially in issue in the subsequent suit must have been heard and finally decided by the court in the first suit. Explanation V of section 11 is to be read with this condition
Progressive solidification is better than the directional solidification and it is independent to the geometry of mould.