Related Questions

রেওয়ামিলে দেনাদার ৫২,০০০ টাকা, লিখিত অনাদারি পাওনা ২,০০০ টাকা এবং অলিখিত অন্যদায়ি পাওনা ২,০০০ টাকা। যদি দেনাদারের ওপর ৫% সঞ্চিতি রাখা হয় এবং অনাদায়ি পাওনা সঞ্চিতির ক্রেডিট ব্যালেন্স ১,০০০ টাকা হয়, তাহলে চলতি বছরে অন্যনায়ি পাওনা সঞ্চিতি কত রাখতে হবে? (In trial balance, account receivable is of Tk. 52,000 recorded bad debt of Tk.2,000 and unrecorded bad debt of Tk. 2,000. What is the amount of allowance for doubtful accounts kept in current year if the allowance is 5% on accounts receivable and credit balance in allowance for doubtful accounts currently is of Tk. 1,000 )
A ২,৫০০ টাকা (Tk. 2,500)
B ১,০০০ টাকা (Tk. 1,000)
C ২,৪০০ টাকা (Tk. 2,400)
D 1,500 টাকা (Tk. 1,500)
In standard taper roller bearings, the angle of taper of outer raceway is
A 5°
B 8°
C 15°
D 25°
The angle of taper on draft tube is
A Greater than 15°
B Greater than 8°
C Greater than 5°
D Less than 8°
Draft allowance given to patterns is for
A compensating the liquid state shrinkage
B easy removal of pattern from the mould cavity
C providing support for the core placement
D compensating the solidification shrinkage
The capacity of induced draft fan compared to forced draft fan in a boiler is
A Same
B More
C Less
D Less or more depending on size of boiler
The main advantage of forced draft over natural draft is that
A Combustion of fuel is complete
B Smaller height chimney can be used
C Furnace control is easier
D All of the above
In die casting, machining allowance is
A Small
B Large
C Very large
D Not provided
Generally, no corrosion allowance in wall thickness of a part is required, if the thickness is more than __________ mm.
A 10
B 20
C 30
D 5
The centrifugal casting method, is used for casting articles of
A Symmetrical shape about vertical axis
B Symmetrical shape about horizontal axis
C Irregular shape
D Nonferrous metal only
A casting defect which results in general enlargement of a casting is known as
A Shift
B Sand wash
C Swell
D Scab

Next steps