Bissoy.com
Doctors Medicines MCQs Q&A

When the molten metal is fed in the cavity of a metallic mould by gravity, the method of casting is known as

When the molten metal is fed in the cavity of a metallic mould by gravity, the method of casting is known as Correct Answer Permanent mould casting method

When the molten metal is fed in the cavity of a metallic mould by gravity, the method of casting is known as Permanent mould casting method

Related Questions

The riser is a reservoir of molten metal provided in the casting so that hot metal can flow back into the mould cavity when there is a reduction in the volume of metal due to?
At the mould exit of a continuous caster, the metal consisting of a solidified shell with a liquid metal core exits at the rate of 35 kg S-1. Given that the latent heat of fusion is 3 × 105 J kg-1 and the total rate of heat removal by the mould is 4.2 × 106 W, the mass fraction of solid at the mould exit is . . . . . . . .
Assume that both while solid and liquid remain at the melting point, they are in the mould.
Molten metal is poured into the mould due to the effect of gravity with _______ external pressure in gravity die casting.
In permanent mould casting, only the metallic type of cores can be used, as the mould material used is also metallic.
When a pattern is to be withdrawn from the mould, it is first shaken, by striking over it from side to side, so that its surface may be free of the adjoining sand wall of the mould. That causes the size of the mould cavity increases a little and a negative allowance is to be provided in the pattern to compensate the same, is known as:
Given that the wave number of a circular cavity resonator is 151 (TE011 mode), and the length of the cavity is twice the radius of the cavity, the radius of the circular cavity operating at 5GHz frequency is:
In vacuum die casting, the molten metal enters into the cavity slowly as compared to the die casting.
The strength of the sand which is required to hold the shape of the mould cavity when the metal in the mould is still in liquid form is known as?
In the squeeze casting method, extreme care is taken while pouring of molten metal into the die cavity.
In permanent mould casting, the mould is pre-heated to its operating temperature before the actual use of mould.