Bissoy.com
Doctors Medicines MCQs Q&A

The adhesiveness is the property of sand due to which

The adhesiveness is the property of sand due to which Correct Answer It clings to the sides of a moulding box

Adhesiveness is that properties of sand due to it adheres or cling to the sides of the moulding box.
It is the property of sand due to which the sand grains stick together during ramming.
It is defined as the strength of the moulding sand.

Related Questions

The following are certain operating problems of a rapid sand filter: 1. Sand depth should never be depleted by more than 10 cm. 2. Air binding results due to development of negative head and formation of air bubbles in the filter sand. 3. Water softening with lime-soda leads to incrustation of sand. 4. Bumping of filter bed is caused due to negative head. Which of the above statements are correct?
Which of the following statements are correct pertaining to the value of uniformity coefficient Cu for filter sand? (1) For slow sand filters, Cu = 1.8 to 2.5 (2) For rapid sand filters, Cu = 1.3 to 1.7 (3) For slow sand filters, Cu = 1.3 to 1.7 (4) For rapid sand filters, Cu = 1.8 to 2.5
Assertion A: Slow sand filters are more efficient in removal of bacteria than rapid sand filters.Reason R: The sand used in slow sand filters is finer than that in rapid sand filtersSelect your answer based on the coding system given below:
Assertion A: Slow sand filters are more efficient in removal of bacteria than rapid sand filters.
Reason R: The sand used in slow sand filters is finer than that in rapid sand filters
Select your answer based on the coding system given below:
The adhesiveness and cohesiveness are the same properties of the molding sand.
Statement I): Incrustation of sand occurs in rapid sand filter when water softened by lime-soda is fed in for filtration. Statement II): The sand gets coated with precipitates of Ca(OH)2 and Mg(OH)2 generated during softening of water by lime-soda process which leads to incrustation of sand.
Consider the following statements in respect of slow sand filter and rapid sand filter: 1. The two filters differ in respect of the standards regarding the non-uniformity of the sand used in their filtering media. 2. The two filters do not differ in respect of the effective size of the sand used in them. 3. The two filters differ in respect of their respective under-drainage system. 4. The two filters differ in respect of their respective rate of filtration. Which of the above statements are correct? 
Which of the following statements are true about quicksand? i. It is only a condition but not a type of sand. ii. It is a condition and a type of sand too. iii. Quicksand condition reaches when critical hydraulic gradient is approximately equal to unity. iv. Quicksand condition occurs more commonly in coarse grained sand or gravels than fine sand.
Cleaning is done by (i) Scraping and removal in filters slow sand (ii) Back washing in slow sand filters (iii) Scraping and removal in filters rapid sand (iv) Back washing in rapid sand filtersThe correct answer is
Cleaning is done by
(i) Scraping and removal in filters slow sand
(ii) Back washing in slow sand filters
(iii) Scraping and removal in filters rapid sand
(iv) Back washing in rapid sand filters
The correct answer is