Related Questions

Societies living in the "periphery" are always ignored. Here the "periphery" word means----
A offshore areas
B marginal areas
C remote places
D backward regions
If Bashar can run around a ground four times in 20 minutes and Rahim can run around the same ground three times in 12 minutes, who can run around that ground more times in an hour, and how many times more can he run around ?
A Bashar, three times more
B Rahim , three times more
C They both go around 12 times
D Bashar, eight times more
Each of the following problem has a question and two statements which are labeled 1. and. Use the data given in 1. and 2. to decide whether the statements are sufficient to answer the question.Select one of the following . a.Statements (1) ALONE is sufficient,but (2) ALONE is not sufficient. b.Statements (2) ALONE is sufficient,but (1) ALONE is not sufficient. c. Both statement TOGETHER are sufficient but statement alone is sufficient . A fly crawls around the outside of a circle once.A second fly crawls around the outside of a square once.Which fly travels further ? (1) The diagonal of the square is equal to the diagonal of the circle.(2) The fly crawling around the circle took more time to complete has journey than the fly cawing around the square.
A A
B B
C C
D D
The diameter of base of conical flare of a steel stack is (where d is the diameter of the cylindrical part)
A Less than d
B Equal to d
C More than d
D Any of the above
A cylindrical storage tank can have a self supported conical roof,
A If its diameter is less than 15-20metres
B If its diameter is more than 50 meters
C If the thickness of the roof is more than that of the cylindrical shell
D Irrespective of its diameter
The operation of machining several surface of a workpiece simultaneously is called
A profile milling
B face milling
C gang milling
D none of these
In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
A Gang milling
B Straddle milling
C String milling
D Side milling
The operation of machining several surfaces of a workpiece simultaneously is called
A Profile milling
B Gang milling
C Saw milling
D Helical milling
An operation of embossing a diamond shaped pattern on the surface of a workpiece, is known as
A Counter-boring
B Grooving
C Knurling
D Facing
Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.
A $$\frac{1}{8}$$ and $$\frac{1}{{64}}$$
B $$\frac{1}{{64}}$$ and $$\frac{1}{8}$$
C $$\frac{1}{2}$$ and 8
D $$\frac{1}{2}$$ and 5

Next steps