Related Questions

In which of the following type of gear train the first gear and the last gear are co-axial.
A Simple gear train
B Compound gear train
C Reverted gear train
D None of the mentioned
While cutting helical gears on a non-differential gear hobber, the feed change gear ratio is
A Independent of index change gear ratio
B Dependent on speed change gear ratio
C Interrelated to index change gear ratio
D Independent of speed and index change gear ratio
In a ________, both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram.
A Simple die
B Progressive die
C Combination die
D Compound die
Cutting and forming operations can be performed in a single operation in a
A Simple die
B Progressive die
C Compound die
D Combination die
The Ackerman steering gear mechanism is preferred to the Davis steering gear mechanism, because
A whole of the mechanism in the Ackerman steering gear is on the back of the front wheels and (
B the Ackerman steering gear consists of turning pairs
C the Ackerman steering gear is most economical
D both (a) and (b)
When the axes of first and last gear are co-axial, then gear train is known as
A simple gear train
B compound gear train
C reverted gear train
D epicyclic gear train
In order to implement gear changes in the gear unit of an automatic transmission, a ___________ is used.
A Synchronizer
B Planetary gear
C Magnetic clutch
D Hydraulic multi plate clutch
In helical gears, the right hand helixes on one gear will mesh __________ helixes on the other gear.
A Right hand
B Left hand
C Both A and B
D None of these
A feed gear box for a screw cutting lathe is designed on the basis of
A Geometric progression
B Arithmetic progression
C Harmonic progression
D None of these
When cutting and pasting, cutting section is temporarily stored in
A Dashboard
B Hard drive
C Diskette
D Clipboard

Next steps