Related Questions

A two stroke cycle engine gives ________ the number of power strokes as compared to the four stroke cycle engine, at the same engine speed.
A Half
B Same
C Double
D Four times
The inlet valve of a four stroke cycle internal combustion engine remains open for
A 130°
B 180°
C 230°
D 270°
Thermal efficiency of a two stroke cycle engine is _________ a four stroke cycle engine.
A Equal to
B Less than
C Greater than
D None of these
Theoretically, a four stroke cycle engine should develop _________ power as that of a two stroke cycle engine.
A Half
B Same
C Double
D Four times
In a four stroke cycle petrol engine, the pressure inside the engine cylinder during the suction stroke is __________ the atmospheric pressure.
A equal to
B below
C above
D middle
In a four stroke cycle diesel engine, the inlet valve
A Opens at 20° before top dead center and closes at 40° after bottom dead center
B Opens at 20° after top dead center and closes at 20° before bottom dead center
C Opens at top dead center and closes at bottom dead center
D May open and close anywhere
In a four stroke cycle petrol engine, the inlet valve
A Opens at top dead center and closes at bottom dead center
B Opens at 20° before top dead center and closes at 40° after bottom dead center
C Opens at 20° after top dead center and closes at 20° before bottom dead center
D May open or close anywhere
Two stroke engine compared to a four stroke engine has
A Higher efficiency
B Less fuel consumption
C Higher power to weight ratio
D Lower initial cost
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If Z is open, which of the following must be true?
A S is open
B T is open
C U is open
D y is open
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If R is closed and U is open, which of the following must be true?
A S is open
B T is open
C T is closed
D Y is closed

Next steps