Related Questions

The size of inlet valve of an engine in comparison to exhaust valve is
A More
B Less
C Same
D More/less depending on capacity of engine
The compression ignition engines are governed by
A Hit and miss governing
B Qualitative governing
C Quantitative governing
D Combination of (B) and (C)
In compression ignition engines, swirl denotes a
A Haphazard motion of the gases in the chamber
B Rotary motion of the gases in the chamber
C Radial motion of the gases in the chamber
D None of the above
In order to eliminate knocking in compression ignition engines, there should be
A Short delay period
B Late auto-ignition
C Low compression ratio
D High self ignition temperature of fuel
The delay period in compression ignition engines depends upon
A Temperature and pressure in the cylinder at the time of injection
B Nature of the fuel mixture strength
C Relative velocity between the fuel injection and air turbulence pressure of residual gases
D All of the above
The knocking tendency in compression ignition engines for a given fuel will be
A Enhanced by decreasing compression ratio
B Enhanced by increasing compression ratio
C Dependent on other factors
D None of the above
The combustion in compression ignition engines is
A Homogeneous
B Heterogeneous
C Both (A) and (B)
D None of these
Combustion in compression ignition engines is
A Homogeneous
B Heterogeneous
C Both (A) and (B)
D Laminar
Antiknock for compression ignition engines is
A Napthene
B Tetra ethyl lead
C Amyl nitrate
D Hexadecane
The higher combustion chamber wall temperature in compression ignition engines will _________ knocking tendency.
A Increase
B Reduce
C Not effect
D None of these

Next steps