Related Questions

By compounding the expansion of steam in two or more cylinders, the length of stroke
A Does not change
B Increases
C Decreases
D None of these
In cross compounding, the cylinders are arranged
A Side by side and each cylinder has common piston, connecting rod and crank
B Side by side and each cylinder has separate piston, connecting rod and crank
C At 90° and each cylinder has common piston, connecting rod and crank
D At 90° and each cylinder has separate piston, connecting rod and crank
A steam turbine, in which a part of the steam after partial expansion, is used for process heating and the remaining steam is further expanded for power generation, is known as
A Back pressure turbine
B Pass out turbine
C Low pressure turbine
D Impulse turbine
Steam reforming of naphtha is a source of hydrogen production for nitrogeneous fertiliser industry. What is the usual ratio of steam to carbon maintained in the process of steam reforming of naphtha?
A 1.5:1
B 3.5:1
C 10:1
D 15:1
Compounding of steam turbine is done for
A reducing the work done
B increasing the rotor speed
C reducing the rotor speed
D balancing the turbine
In a steam engine, superheated steam from the boiler is fed into the steam chest at a pressure of
A 10 atmospheres
B 20 atmospheres
C 30 atmospheres
D 40 atmospheres
The isentropic expansion of steam through nozzle for the steam initially superheated at inlet is approximated by equation
A pvls=C
B pv1126 = C
C pv1A = C
D pv = C
The isentropic expansion of steam through nozzle for the steam initially dry saturated at inlet is approximated by equation.
A pv = C
B pv1A = C
C pv1i = C
D pv
The process of draining steam from the turbine, at certain points during its expansion and using this steam for heating the feed water in feed water heaters and then supplying it to the boiler is known as
A Regenerative heating
B Reheating of steam
C Bleeding
D None of these
In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.
A Equal to
B Less than
C More than
D None of these

Next steps