Related Questions

L is older than M and taller than N. O is younger than P, older than N and shorter than Q. R is older than S, younger than N, shorter than S and taller than Q. S is older than L, M, O, P, Q, R and S is necessarily false?
A O is the shortest of the group.
B N is the second tallest of the group.
C L is the tallest of the group.
D Q is the third oldest of the group.
In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by
A Convection
B Radiation
C Conduction
D Both convection and conduction
The rate of heat transfer from a vertical plate by natural convection depends upon the temperature differences (ΔT) between wall and outside bulk. The proportionality is given as
A $${\left( {\Delta {\text{T}}} \right)^{\frac{1}{4}}}$$
B $${\left( {\Delta {\text{T}}} \right)^{\frac{1}{2}}}$$
C $${\left( {\Delta {\text{T}}} \right)^{\frac{5}{4}}}$$
D $${\left( {\Delta {\text{T}}} \right)^{\frac{3}{4}}}$$
Heat transfer occurs by natural convection because change in temperature causes difference in
A Viscosity
B Density
C Thermal conductivity
D Heat capacity
Rahim's convertible gets gas mileage that is 40% higher than that of Karim's SUV. If Jalil's hatchback gets gas mileage that is 15% higher than of Rahim's convertible, then that of Rahim's convertible, then Jalil's hatchback gets gas mileage that is what percent greater that of Karim's SUV?
A 46%
B 55%
C 61%
D 25%
When the air is passed through an insulated chamber having sprays of water maintained at a temperature higher than the dew point temperature of entering air but lower than its dry bulb temperature, then the air is said to be
A Cooled and humidified
B Cooled and dehumidified
C Heated and humidified
D Heated and dehumidified
The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
A 0
B 100
C 50
D None of these
How are the efficiencies of any heat engine (miu) and reversible heat engine (miuR) compared, when both are operating between same heat source and same heat sink?
A miu = miuR
B miu>miuR
C miu
D none of these
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
A scaling factor
B forming factor
C resisting factor
D fouling factor
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base

Next steps