The refrigerant after condensation process is cooled below the saturation temperature before throttling. Such a process is called

The refrigerant after condensation process is cooled below the saturation temperature before throttling. Such a process is called Correct Answer Sub-cooling or under-cooling

The refrigerant after condensation process is cooled below the saturation temperature before throttling. Such a process is called Sub-cooling or under-cooling
Bissoy MCQ

Related Questions

What is the ratio of the mass of refrigerant flowing through condenser and mass of refrigerant flowing through the evaporator, i.e., m2 / m1? If m1 = mass of refrigerant passing through the evaporator m2 = mass of refrigerant passing through the condenser
Consider the following statements (i) If a condensing liquid does not wet a surface, then drop wise condensation will not take place on it (ii) Drop wise condensation gives a higher transfer rate than film wise condensation (iii) Reynolds number of condensing liquid is based on its mass flow rate (iv) Suitable coating or vapor additive is used to promote film wise condensation Identify the correct statement
Statement 1: Film-type condensation has a higher heat transfer co-efficient than drop-wise condensation. Statement 2: Drop-wise condensation is easier to maintain than Film-type condensation
The difference between the saturation temperature T3 of liquid refrigerant at pressure p3 = p2 and the actual temperature of liquid refrigerant T3′ is called?
The heat treatment process in which a steel is heated to a temperature below the A1 (Temperature is below process annealing temperature) and is held at this temperature for sufficient time and then cooled is called
The process of under cooling the refrigerant below the saturation temperature happens after?
___________ is the difference between the boiling point temperature of the refrigerant in the evaporator coil and the actual temperature of the refrigerant gas as it leaves the evaporator.
Fog formation in a condenser can occur when the temperature of the vapour-gas mixture _____________ the local saturation temperature during the condensation process.
The temperature at which a gas, when subjected to Joule-Thomson expansion, neither cools or heats up, is termed as the __________ temperature. Above this temperature the gas heats up on throttling and below this the gas cools down.
Reverse collector saturation is greater than Reverse saturation current because of reverse collector saturation __________