Related Questions

A gas turbine used in air craft should have
A High h.p. and low weight
B Low weight and small frontal area
C Small frontal area and high h.p.
D High speed and high h.p.
The pressure ratio for an open cycle gas turbine compared to closed cycle gas turbine of same h.p. is
A Low
B High
C Same
D Low/high depending on make and type
A closed cycle gas turbine gives ________ efficiency as compared to an open cycle gas turbine.
A Same
B Lower
C Higher
D None of these
The specific speed of a turbine is the speed of an imaginary turbine, identical with the given turbine, which
A Delivers unit discharge under unit head
B Delivers unit discharge under unit speed
C Develops unit power under unit head
D Develops unit power under unit speed
If infinite number of heaters be used in a gas turbine, then expansion process in turbine approaches
A Isothermal
B Isentropic
C Adiabatic
D Isochoric
The following cycle is used for air craft refrigeration
A Brayton cycle
B Joule cycle
C Carnot cycle
D Reversed Brayton cycle
What type of fusion welding process is used for welding sheet metals of all engineering metals (except Cu, Ag) in automobile and air craft industries, pipe and tubing production?
A Thermit welding
B Electroslag welding
C Resistance welding
D Submerged arc Welding
There is a certain pressure ratio (optimum) for a gas turbine at which its thermal efficiency is maximum. With increase in turbine temperature, the value of pressure ratio for the peak efficiency would
A Remain same
B Decrease
C Increase
D None of the above
The weight per horse power ratio for gas in Turbine as compared to I.C. engine and steam turbine is
A Same
B Higher
C Lower
D None of these
Gas turbine as compared to steam turbine
A Requires less space for installation
B Has compressor and combustion chamber
C Has less efficiency
D All of these

Next steps