Related Questions

Read the paragraph and answer the question-photosynthesis is a process in which radiant energy from sun is stored as chemical energy , which in turn is used to decompose carbon dioxide and water. The product of their decomposition are recombined into a new compound which successively builds, up into more and more complex organic substances like sugars, starches and cellulose that comprise the plant.The word stored in the paragraph is closest in morning to
A specified
B retained
C converted
D discovered
The strain energy stored in a body, when suddenly loaded, is __________ the strain energy stored when same load is applied gradually.
A Equal to
B One-half
C Twice
D Four times
STP-তে একটি আদর্শ গ্যাসকে প্রথমে তার প্রাথমিক আয়তনের এক-তৃতীয়াংশে সংকুচিত করা হয়, এবং তারপর প্রসারিত হতে দেওয়া হয় যতক্ষণ না তার চাপ প্রাথমিক চাপের অর্ধেক হয়। উভয় প্রক্রিয়ায় গ্যাসের তাপমাত্রা স্থির থাকে। যদি গ্যাসের প্রাথমিক অভ্যন্তরীণ শক্তি । হয়ে থাকে তাহলে এর চূড়ান্ত অভ্যন্তরীণ শক্তি কত? (An ideal gas at STP is first compressed to one-third of its initial volume and then allowed to expand until its pressure is half the initial pressure. The temperature of the gas remains constant during both the processes. If the initial internal energy of the gas is U, what is its final internal energy?)
A U/3
B U/2
C U
D 2U/3
The temperature at which a gas, when subjected to Joule-Thomson expansion, neither cools or heats up, is termed as the __________ temperature. Above this temperature the gas heats up on throttling and below this the gas cools down.
A Isotactic
B Saturation
C Inversion
D Throttling
In which form is the supplied heat energy stored during change in temperature of substance?
A Heat energy
B Kinetic energy
C Potential energy
D Both kinetic and potential energy
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
A device used to increase the temperature of saturated steam without raising its pressure, is called
A Blow off cock
B Fusible plug
C Superheater
D Stop valve
How are the efficiencies of any heat engine (miu) and reversible heat engine (miuR) compared, when both are operating between same heat source and same heat sink?
A miu = miuR
B miu>miuR
C miu
D none of these
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
A scaling factor
B forming factor
C resisting factor
D fouling factor

Next steps