Related Questions

What is the usual value of angle of nip for crushing of ordinary rock in smooth steel crushing rolls?
A 16°
B 32°
C 40°
D 46°
The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is _________ cutting speed for drilling mild steel with high speed steel drills.
A Equal to
B Less than
C More than
D None of these
The length of each side of square A is increased by 100 percent to make square B. Again the length of each side of square B is increased by 50 percent to make square C. By what percent is the area of square C greater than the sum of the areas of square A and B?
A 75%
B 80%
C 85%
D 90%
Choke crushing (in case of a Jaw crusher) compared to free crushing
A Results in increased capacity
B Consumes less power
C Consumes more power
D Both A and C
For crushing of solids, the Rittinger's law states that the work required for crushing is proportional to
A The new surface created
B The size reduction ratio
C The change in volume due to crushing
D None of these
When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)
A 0.5 d
B 0.75 d
C d
D 1.25 d
Tensile strength of a mild steel specimen can be roughly predicted from following hardness test
A Brinell
B Rockwell
C Vickers
D None of the above
For machining a mild steel workpiece by a high speed steel tool, the average cutting speed is
A 5 m/min
B 10 m/ min
C 15 m/min
D 30 m/min
The allowable tensile stress in structural mild steel plates for steel tank is assumed as
A 95.0 MPa on net area
B 105.5 MPa on net area
C 105.5 MPa on gross area
D 150.0 MPa on gross area
The average cutting speed for turning mild steel with a high speed steel tool is
A 15 to 19 m/min
B 25 to 31 m/min
C 60 to 90 m/min
D 90 to 120 m/min

Next steps