Related Questions

Machine A produces bolts at a uniform rate of 120 every 40 seconds and Machine B produces bolts at a uniform rate of 100 every 20 seconds. If the two machines run simultaneously , how many seconds will it take for them to produce a total of 200 bolts.
A 22
B 25
C 28
D 32
Machine A produces bolts at a uniform rate of 120 every 40 seconds, and Machine B produces bolts at a uniform rate of 100 every 20 seconds. If the two machines run simultaneously, how many seconds will it take for them to produce total of 200 bolts?
A 22
B 25
C 28
D 32
If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation
A 124 d
B 138 d
C 151 d
D 168 d
A tank is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the tank in the same time during which the tank is filled by the third pipe alone. The second pipe fills the tank 5 hours faster than the first pipe and 4 hours slower than the third pipe. The time required by the first pipe is:
A 6 hours
B 10 hours
C 15 hours
D 30 hours
The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)
A 1420 d
B 1680 d
C 2080 d
D 2840 d
As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint is the __________ joint.
A Butt
B Lap
C Welded
D None of these
In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)
A 2 d
B 3 d
C 4 d
D 5 d
A pipe of 2 inch diameter fills a water tank in one hour. If the diameter of the pipe is 4 inch in what time will the pipe fill the same tank?
A 10 minutes
B 15 minutes
C 30 minutes
D 45 minutes
A pipe of 2 inch diameter fills a water tank in one hour . If the diameter of the pipe is 4 inch in what time will the pipe fill the same tank?
A 10 minutes
B 15 minutes
C 30 minutes
D 45 minutes
When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)
A 0.5 d
B 0.75 d
C d
D 1.25 d

Next steps