Related Questions

A machine started malfunctioning due to some issues with the coupling. The coupling emplaced in the machine was Oldham. The only coupling available in the workshop is Hooke’s coupling. So Oldham coupling can be replaced by Hooke’s coupling.
Hollow shafts can be made as strong as solid shafts by making the twisting moments of both the shafts same. Shafts made by __________ have residual stresses.
Find the approximate thickness of web if b is 0.5d, d is 270mm, d/h ratio is 0.85, h is 315mm, adopt effective depth, d = 275mm overall depth , h is 320mm, width of flange of 160mm and Average thickness of flange is 70mm since sloping flanges are used, increases the flange thickness by 20 percent?
As per IS : 800, for compression flange, the outstand of flange plates should not exceed (where t = thickness of thinnest flange plate)
In a marine flange coupling, the thickness of flange is taken as
Find the shear stress in a flange at the junction of hub in rigid flanged coupling if torsional moment is 2980N-m and diameter of hub being 125mm. Also the thickness of flange is 25mm.
For an Oldham coupling used between two shafts, which among the following statements are correct? I. Torsional load is transferred along shaft axis. II. A velocity ratio of 1:2 between shafts is obtained without using gears. III. Bending load is transferred transverse to shaft axis. IV. Rotation is transferred along shaft axis.
Which of the coupling is used to couple the two shafts which are parallel to each other and the axes of shafts are separated by a distance.
Determine the diameter of the bolts used in rigid flange coupling if transmitted torque is 270N-m, pitch circle diameter=125mm and four bolts are emplace in the coupling. Permissible shear stress in the bolts is 70N/mm².
In a flange coupling, the keys are staggered at __________ along the circumference of the shafts in order to divide the weakening effect caused by key ways.