Related Questions

The algebraic difference between the minimum limit and the basic size is called
A Actual deviation
B Upper deviation
C Lower deviation
D Fundamental deviation
The maximum shear stress is __________ the algebraic difference of maximum and minimum normal stresses.
A Equal to
B One-fourth
C One-half
D Twice
The difference between the upper limit and lower limit of a dimension is called
A Nominal size
B Basic size
C Actual size
D Tolerance
On Dhaka- Sylet highway , 5% of the drives are fined for exceeding the speed limit. However , 80% of the drivers who exceed the speed limit are not fined. What percentage of dirvers on this highway exceed the speed limit?
A 10
B 15
C 20
D 25
Vertical curves are provided where algebraic difference between grades is equal to or
A less than 2 mm/m
B more than 2 mm/m
C less than 4 mm/m
D more than 4mm/m
The lower deviation is the algebraic difference between the
A Actual size and the corresponding basic size
B Maximum limit and the basic size
C Minimum limit and the basic size
D None of the above
The difference between a two-digit number and the number obtained by interchanging the digits is 36. What is the difference between the sum and difference of the digits of the number if the ratio between the digits the number is 1 : 2?
A 4
B 8
C 16
D 24
The difference between the radio of bigger difference between circle and smaller circle is 14 and the difference between their sareas is 1056 cm2 . Radius of the smaller circle is .
A 7 cm
B 5 cm
C 9 cm
D 3 cm
what is the monthly salary of Rahman ? Statements : 1. Rahman's basic salary is Tk. 100 more Rajan's salary who also serves in Rahman's company. 2. Other allowances drawn by Rajan besides his basic salary are Tk. 2,000 per month which is TK. 50 less than Rahan's salary . 3. Rajan's basic salary is TK. 1550 per month.
A Only II
B Only II and III
C Only I and II
D All I , II and II
Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to
A Dynamic loading
B Static loading
C Combined static and dynamic loading
D Completely reversed loading

Next steps