Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following circuits: 1. Full adder 2. Half adder 3. JK flip-flop 4. Counter Which of the above circuits are classified as sequential logic circuits?
There are 3 clocks located at California, Berlin and Beijing respectively. If the hour hand of the clock at California is rotated by 270 degrees, then it will show same time as clock in Berlin. If the hour hand of clock in Berlin is rotated by 180 degrees, then it will show same time as clock in Beijing. If time at clock at Beijing is 8 : 30 PM what time is clock at California showing?
A clock strikes once at 1 o'clock, twice at 2 o'clock and thrice at 3 o'clock, and so on. If it takes 12 seconds to strike at 5 o'clock, what is the time taken by it to strike at 10 o'clock?
On a non-pipelined sequential processor, a program segment, which is a part of the interrupt service routine, is given to transfer 500 bytes from an I/O device to memory.     Initialize the address register     Initialize the count to 500 LOOP: Load a byte from device     Store in memory at address given by address register     Increment the address register     Decrement the count     If count! = 0 go to LOOP Assume that each statement in this program is equivalent to a machine instruction which takes one clock cycle to execute if it is a non-load/store instruction. The load-store instructions take two clock cycles to execute. The designer of the system also has an alternate approach of using the DMA controller to implement the same transfer. The DMA controller requires 20 clock cycles for initialization and other overheads. Each DMA transfer cycle takes two clock cycles to transfer one byte of data from the device to the memory. What is the approximate speedup when the DMA controller based design is used in place of the interrupt driven program based input-output?
A government official said, “Currently, the traffic signals installed along the roads have a fixed signal timer but with the Japanese technology, signals will automatically change according to the number of vehicles along the road.” Which of the following could be the reason for the statement? I: The installation of smart signals will reduce the waiting time at signals and junctions. II: The installation of smart signals will solve the traffic woes in the city. III: The technology will be an integrated traffic management center that will ease congestion in the city.
A 5-stage pipelined processor has Instruction Fetch (IF), Instruction Decode (ID), Operand Fetch (OF), Perform Operation (PO) and Write Operand (WO) stages. The IF, ID, OF and WO stages take 1 clock cycle each for any instruction. The PO stage takes 1 clock cycle for ADD and SUB instructions, 3 clock cycles for MUL instruction, and 6 clock cycles for DIV instruction respectively. Operand forwarding is used in the pipeline. What is the number of clock cycles needed to execute the following sequence of instructions? Instruction Meaning of instruction I0 : MUL R2, R0, R1 R2← R0 * R1 I1 : DIV R5, R3, R4 R5 ← R3 / R4 I2 : ADD R2, R5, R2 R2 ← R5 + R2 I3 : SUB R5, R2, R6 R5 ← R2 – R6
Based on the paragraph given below answer the following question: The traditional methods of combinational circuits involve simplification and realization using gates. Using these methods, complex functions have been integrated and are easily available in IC form. There is an attractive array of devices like a multiplexer, demultiplexer, decoders, comparators, parity generators/checkers, which significantly reduce IC package count there by reducing the system cost. The system design is greatly simplified because the laborious and time-consuming simplification methods are generally not required with these devices. This also improves the reliability of the system by reducing the number of external wired connections. But they have some limitations as well. Different memories like ROM, PROM can also be used to implement combinational circuits without much simplification.   Consider the following digital circuits. 1. Multiplexers 2. Read Only Memories 3. D-latch 4. Circuit as shown in figure below Which of these come under the class of combinational circuits?
A clock strikes once at 1 O'clock, twice at 2 O'clock twice at 2 O'clock, thrice at 3 O'clock and so on. How many times will it strike in 24 hours
Three friends converted the time of 24 hours clock in that of 12 hour clock as follows: Name of the children Time in 24 hour clock Time in 12 hour clock Cheeku 23:45 11:45 pm Bittu  16:30 04:30 am Pinki 19:28 07:28 pm Who has shown incorrect time in 12 hour clock?
A clock rings once in 1 O' clock, twice in 2 O' clock and thrice in 3 O' clock and so on, then how much time the clock ring in a day (24 hours)?