Related Questions

Which command of DOS is used to compare two floppy disks?
A DISKCOPY
B DISKCOMP
C DISKCOPY A: B/V
D FORMAT A: B:
E None of the above
Which internal DOS command clears the screen and places the DOS prompt in the upper left corner of the screen?
A cls
B close
C quit
D exit
E None of the above
While working with MS-DOS, which command is used to force DOS to recheck all clusters when reformatting a disk?
A FORMAT/B
B FORMAT/S
C FORMAT/8
D FORMAT/C
E None of the above
While working with MS-DOS, which command is used to display a list of deleted files that DOS can undelete?
A UNDELETE *.*
B UNDELETE/ALL
C UNDELETE/LIST
D UNDELETE
E None of the above
After upgrading your computer to a new DOS version, an older application displays the error message "Incorrect DOS version". What should you do to run this application?
A Use the DOS+ command
B Use the SETVER command
C Restore the old DOS version
D Contact the application's vendor support line
E None of the above
Which DOS command is used to detect, diagnose and repair logical and physical disk errors on both, uncompressed and Double space compressed drive?
A DEFRAG
B DBLSPACE
C SCANDISK
D MSAV
E None of the above
Hard disks are formatted in the same manner as floppy disks. However, before a hard disk can be formatted, it must first be _____
A partitioned
B sectioned
C deleted
D inter-sectioned
E write protected
DOS uses letters of the alphabet to designate disk drives. How many disk drives can DOS address (recognize)?
A 4
B 26
C 1
D 16
E None of the above
If you do not know which version of MS-DOS you are working with, which command will you use after having booted your operating system?
A FORMAT command
B DIR command
C VER command
D DISK command
E None of the above
While working with MS-DOS, which command is used to restore files that were backed up using the BACKUP command?
A COPY
B DISKCOPY
C RESTORE
D STORE
E None of the above

Next steps